Geothermal Earth Loops for Reading

In part three of our Introduction to Geothermal series, we are going to discuss geothermal loop systems and how each type works.

A geothermal loop is the series of underground pipes used to move heat to and from the earth. The pipes are formed out of high-density polyethylene to secure a durable, long-lasting system. They are joined together by the process of thermal fusion that will forge a bond that is much stronger than the original pipe itself. In fact, a properly installed loop can last up to 200 years.
 
There are two leading types of geothermal loop systems that are almost always used in today's installs: open loop systems and closed loop systems. Both systems have unique pros and cons for your heating or cooling solution. We at Paul W. Essig Inc. have the knowledge and expertise on both types, and we will guide you step by step in the process of determining the best choice for your geothermal installation.

Open loop geothermal solutions are designed to utilize the natural groundwater from under your home. Using a well, water is drawn from an existing aquifer and relocated to the geothermal heat pump where its heat is withdrawn and the water is pushed back into the ground or to an assigned runoff. Since the water that you are handling is not being treated in any way, the only thing that is being returned to the ground is water that is slightly warmer or cooler (depending whether you're in heating or cooling mode).

One consideration to watch out for with an open loop system is water quality. Mineral build-up can manifest from poor quality water. This can be kept under control with an occasional cleaning. If the water in the earth has greater iron content, you will need to make sure that the discharge water is prevented from coming in contact with air before it is returned to prevent clogs.
 
Closed loops are precisely as they sound. Rather than pumping water from a well and depositing it elsewhere, water is circulated in a fully sealed circuit with a small amount of environmentally-friendly antifreeze.
 
There are two primary types of closed loop installations: horizontal and vertical. Installing the system horizontally requires a good chunk of land. The piping is embedded in trenches between 4 and 6 feet deep and can be up to 400 feet long. If you reside on a smaller lot, the loops can be installed vertically by boring straight down using drilling equipment. This form of installation can be installed in as little as a 10ft by 10ft  area.
 
In either case, the larger the building, the larger the geothermal heat pump and loop needs to be. A good ball park figure is that for every ton of system capacity, you will need 500 to 600 feet of pipe.
 
Contact Paul W. Essig Inc. today to learn more about what system options are available to you here in Reading.